HENAX Sp. z o.o.
ul. Lodowa 122
PL-93-232 Łódź
tel.:+48 42 6772200
fax.:+48 42 6491515
email: Ten adres pocztowy jest chroniony przed spamowaniem. Aby go zobaczyć, konieczne jest włączenie w przeglądarce obsługi JavaScript.

ACMOSIL 34-4048

No image set

[translation needed] Release Agent for manufacturing PUR in the shoe industry, mainly for direct injection of shoe-soles of dual density


Sprayable Release Agent with a high content of active substances (High Solid)


Excellent release

Minimal cleaning stops

Economic in use: In contrary to solvent based Release Agents amount to be sprayed can be reduced to 1/5 or 1/10.

Easy to use


Contents of drum must be well stirred before and during use. The Release Agent should be at room temperature before processing.

We recommend using needle-controlled air-assisted spray-guns. At normal cycle times the material output should be about 15 grs/min. This can be achieved by using nozzles of a diameter of 0,3 - 0,5 mm and a material pressure of about 0,5 bar.

Before first coating is applied the mould should be cleaned with an ACMOSOL Mould Cleaner. New or cleaned moulds should be sealed with the Release Agent two or three times before filling.


Stir up thoroughly before use. Do not store outdoors. Protect from heat and cold. To use only under permanent stirring. Allow products to reach room temperature before use.

Storage temperature: between 10° C and 30° C.