HENAX Sp. z o.o.
ul. Lodowa 122
PL-93-232 Łódź
tel.:+48 42 6772200
fax.:+48 42 6491515
email: Ten adres pocztowy jest chroniony przed spamowaniem. Aby go zobaczyć, konieczne jest włączenie w przeglądarce obsługi JavaScript.

ACMOS 39-4487

No image set

[translation needed] External Release Agent for manufacturing PUR, mainly for semi-rigid and filling foams


Sprayable Release Agent with a high content of active substances (High Solid)


Excellent release

Minimal cleaning stops

Economic in use: In contrary to solvent based Release Agents amount to be sprayed can be reduced to 1/3 or 1/4.

Easy to use


Contents of drum must be well stirred before and during use.

The Release Agent should be at room temperature before processing.

We recommend using needle-controlled air-assisted spray-guns. At normal cycle times the material output should be about 30 to 40 grs/min. This can be achieved by using nozzles of a diameter of 0,3 - 0,5 mm and a material pressure of about 0,5 bar.

Before first coating is applied the mould should be cleaned with an ACMOSOL Mould Cleaner.

New or cleaned moulds should be sealed with the Release Agent two or three times before filling.


Stir up thoroughly before use. Do not store outdoors. Protect from heat and cold. To use only under permanent stirring. Allow products to reach room temperature before use.

Storage temperature: between 10° C and 30° C.