HENAX Sp. z o.o.
ul. Lodowa 122
PL-93-232 Łódź
 
tel.:+48 42 6772200
fax.:+48 42 6491515
email: This email address is being protected from spambots. You need JavaScript enabled to view it.

ACMOS 35-4180

No image set

Release Agent for manufacturing PUR, mainly for rigid and rigid integral foams

PROPERTIES:

Sprayable Release Agent with a high content of active substances (High Solid)

The Release Agent is free from silicone !

ADVANTAGES:

Excellent release

Minimal cleaning stops

Economic in use: In contrary to solvent based Release Agents amount to be sprayed can be reduced to 1/3 or 1/4.

Easy to use

PROCESSING:

Contents of drum must be well stirred before and during use. The Release Agent should be at room temperature before processing.

We recommend using needle-controlled air-assisted spray-guns. At normal cycle times the material output should be about 30 to 40 grs/min. This can be achieved by using nozzles of a diameter of 0,3 - 0,5 mm and a material pressure of about 0,5 bar.

Before first coating is applied the mould should be cleaned with an ACMOSOL Mould Cleaner. New or cleaned moulds should be sealed with the Release Agent two or three times before filling.

STORAGE:

Stir up thoroughly before use. Do not store outdoors. Protect from heat and cold. To use only under permanent stirring. Allow products to reach room temperature before use.

Storage temperature: between 10° C and 30° C.